Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ Power supply system and production of the fulfilled gases
- System of electric equipment of the engine
   General information
   Start of the engine from an auxiliary source
   Check of a state and replacement of wires of the battery
   Removal and installation of the battery
   System of ignition - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the sensor of position of the camshaft
   Removal and installation of the distributor
   System of a charge - the general information and precautionary measures
   Check of serviceability of functioning of system of a charge
   Removal and installation of the generator
   System of start
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and installation of a starter
   Removal and installation of the traction relay (4.0 l engines)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the battery

If the car is transferred to the non-use mode (the engine will not be started) for the term of more than 20 days, it is necessary to remove IOD safety lock in distribution center of power supply in order to avoid an excessive discharge of the battery.


 PERFORMANCE ORDER

  1. Disconnect both wires from the battery.

First of all always disconnect from the battery a negative wire in order to avoid casual short circuit at an otdavaniye of a terminal clip positive.


If the radio tape recorder in your car is equipped with a security code before disconnecting a negative wire from the battery make sure that you know this code.

  1. Remove a clamping level of the battery.
  1. Give two nuts (shooters), then remove a clamping level from the battery.
  1. Remove the thermofilter from the battery.
  1. Remove the battery. Be careful - it weighs quite a lot.

In shops of automobile accessories for reasonable price it is possible to get the special, equipped with handles bandages for simplification of the procedure of extraction of the battery from the car.

  1. Having removed the battery, check a condition of her holder (pallet) (for existence of traces of corrosion and other damages).
  2. If corrosion passed to a battery arm, give bolts and remove an arm. Cleaning of a support with use of solution of baking soda will help to protect an arm from further oxidation.
  1. Components of the pallet and clamping level of the battery.
  1. If the battery needs to be replaced, track that again acquired battery on a design, a standard size and output characteristics corresponded to replaced.
  2. You make installation upside-down.