Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ Power supply system and production of the fulfilled gases
- System of electric equipment of the engine
   General information
   Start of the engine from an auxiliary source
   Check of a state and replacement of wires of the battery
   Removal and installation of the battery
   System of ignition - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the sensor of position of the camshaft
   Removal and installation of the distributor
   System of a charge - the general information and precautionary measures
   Check of serviceability of functioning of system of a charge
   Removal and installation of the generator
   System of start
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and installation of a starter
   Removal and installation of the traction relay (4.0 l engines)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the traction relay (4.0 l engines)

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped with a security code before disconnecting a negative wire from the battery make sure that you know this code.

  1. Remove a starter (The section Removal and installation of a starter).
  2. Disconnect the tire going from the traction relay to the starter plug.
  1. For separation of the traction relay from a starter remove a starter and disconnect the tire from the starter plug of the relay (shooter).
  1. Give screws of fastening of the traction relay to a starter and remove the relay.
  1. For a detachment of the traction relay from a starter give fixing screws (shooters) in its forward part (the starter of Mitsubishi is shown).
  1. Having removed the traction relay check a condition of teeth of a gear wheel of a starter. If teeth are damaged, it is necessary to examine also gear wreath of a flywheel / a driving disk.
  2. You make installation upside-down.