Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ Power supply system and production of the fulfilled gases
- System of electric equipment of the engine
   General information
   Start of the engine from an auxiliary source
   Check of a state and replacement of wires of the battery
   Removal and installation of the battery
   System of ignition - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the sensor of position of the camshaft
   Removal and installation of the distributor
   System of a charge - the general information and precautionary measures
   Check of serviceability of functioning of system of a charge
   Removal and installation of the generator
   System of start
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and installation of a starter
   Removal and installation of the traction relay (4.0 l engines)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the generator

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped with a security code before disconnecting a negative wire from the battery make sure that you know this code.

  1. Mark and disunite electric sockets and the tire of grounding on the generator.
Electric sockets of the generator.
  1. Turn a pulley of a natyazhitel and take off a driving belt.
  1. Turn a pulley of a natyazhitel clockwise, having removed a tension of a driving belt of tape type (the engine of 5.2 l is shown).
  1. Give adjusting and axial bolts and remove the generator from the engine.

Removal of bolts of the top arm of the generator (the engine of 5.2 l is shown).

  1. The second key hold a bolt from a provorachivaniye at a nut otdavaniye.
  1. When replacing the generator take with yourself in shop old. Track that the new / restored block acquired was identical to removed. Examine plugs - they have to coincide by quantity, the size and location. In conclusion compare identification numbers - they have to be beaten out on the case of the generator or are printed on the label attached to the case. Numbers of both blocks have to coincide.
  2. Most often new blocks are delivered without pulleys therefore rearrange a pulley from the removed generator on new / restored.
  3. You make installation upside-down.
  4. After installation of the generator make adjustment of a tension of a driving belt (The head Nastroyki and routine maintenance).
  5. For check of serviceability of functioning of the new generator measure its charge voltage (Section Check of Serviceability of Functioning of System of a Charge).