Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
- Power supply system and production of the fulfilled gases
   General information
   Procedure of dumping of pressure of fuel
   Check of pressure of fuel and functioning of the fuel pump
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - the general information
   Repair and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of serviceability and replacement of the block of the fuel level sensor
   Removal and installation of assembly of the air cleaner
   Replacement of a cable of gas
   System of injection of fuel - the general information
   Check of serviceability of system of injection of fuel
   Serviceability check, removal and installation of the case of a throttle
   Check of serviceability and replacement of the regulator of pressure of fuel
   Serviceability check, removal and installation of injectors of fuel
   Check of functioning and replacement of components of system of stabilization of turns of idling (IAC)
   Service of system of production of the fulfilled gases - the general information
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the fuel tank

See the prevention at the beginning of the Section Procedure of Dumping of Pressure of Fuel.


This procedure considerably will become simpler if by the time of its carrying out the fuel tank is emptied. The tank is not equipped with a drain stopper therefore fuel should be sucked away from it by means of special set - ask in shops of automobile accessories. Do not suck away fuel from a tank a mouth AT ALL!


 PERFORMANCE ORDER

  1. Uncover a jellied mouth for dumping of excessive pressure in a tank.
  2. Dump pressure in a power supply system (Section Procedure of Dumping of Pressure of Fuel).
  3. Disconnect a negative wire from the battery.
  4. Suck away fuel from a tank in specially intended for its storage the capacity (canister). Use for implementation of this procedure by set for suction of fuel of a tank (ask in shops of automobile accessories).
  5. If that is provided, remove the service electric socket fixed on a car bumper.
  1. If the car is equipped with the trailer, give four bolts (arrow) of fastening of the service socket.
  1. Prop up a strange plate (if that is provided) a cart jack, give bolts of fastening of a strange plate of the fuel tank and carefully lower a plate, separating it from car chassis elements.
  1. Having taken care of adequate support of a strange plate a jack, give bolts of its fastening.

Components of the fuel tank.

  1. If the car is in addition equipped with a turnbuckle, give four bolts and separate an arm from back section.
  2. Give fixing bolts and remove the thermofilter of an exhaust pipe.
  3. Mark and disconnect all fuel hoses and arms used for their fastening.
  1. Having hooked a screw-driver sting, take the plug through passage and take the holder of the fuel line from a chassis element.
  1. Squeeze lock uvulas of nipple connection and separate the line of return of fuel.
  1. Squeeze lock uvulas on lines of the fuel filter and separate lines.
  1. Having hooked a screw-driver sting, take the electric socket of the fuel pump from a chassis element.
  1. Prop up the fuel tank a cart jack. Between a head of a jack and a surface of a tank for distribution of loading lay rather long wooden whetstone.
  2. Disconnect both brackets of fastening of a tank and 15povernite them down that they hung, without preventing removal of a tank.
  1. Give nuts of brackets of fastening of the fuel tank.
  1. Disconnect a reception hose and a hose of return of evaporations from a tank.
  1. Remove fastening collars to a tank of hoses of reception of fuel and return of evaporations.
  1. Remove a tank from the car.
  1. Slowly lower a tank and take it from under the car.
  1. You make installation upside-down.