Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
- V8 engine
   General information
   Repair procedures which implementation does not demand extraction of the engine from the car
   Reduction in the provision of VMT of the piston of the first cylinder
   Removal and installation of covers of heads of cylinders
   Removal, check of a state and installation of yokes and bars of pushers
   Replacement of valvate springs, their plates and maslootrazhatelny caps
   Removal and installation of the inlet pipeline
   Removal and installation of final collectors
   Removal and installation of heads of cylinders
   Replacement of a forward epiploon of a bent shaft
   Removal, check of a state and installation of a cover of a distributive chain, chain and its asterisks
   Removal, check of a state and installation of the camshaft and hydraulic pushers
   Removal and installation of the pallet of a case
   Removal, check of a state and installation of the oil pump
   Removal and installation of a flywheel / driving disk
   Replacement of a back radical epiploon
   Check of a state and replacement of rubber pillows of support of the engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Repair procedures which implementation does not demand extraction of the engine from the car

Many of procedures of the general repair of the engine can be executed without removal of the last from the car.

Before getting to the main work make cleaning of a motive compartment and the external surfaces of the engine. Cleaning has to be careful, with application of a pressure or couple. It will help to facilitate considerably the forthcoming work and to prevent hit in internal cavities and galleries of the engine of dirt.

Depending on the nature of the forthcoming work removal of a cowl of the car (Head Kuzov) for ensuring access to the corresponding components can be required.

If existence of leak of oil, a cooler, the fulfilled gases or loss of depression demands carrying out replacement of laying or epiploons, these procedures can be completely performed without removal of the engine. Access to laying of the inlet pipeline, a final collector, the pallet of a case, heads of cylinders, covers of a distributive chain and to epiploons of a bent shaft is quite possible without extraction of the engine from the car.

Removal and repair of the components installed outside on the engine, such as inlet pipeline and final collector, water pump, starter, generator, distributor and carburetor (power supply system components) also does not demand removal of the engine from the car.

As heads of cylinders can be removed without extraction of the engine, service of components of the valvate mechanism is also among the procedures considered in this Chapter.

Do not demand removal of the engine also of the procedure check of a state, repair and replacements of a distributive chain with asterisks and the oil pump.

In extreme situations, in the conditions of acute shortage of the necessary equipment, without extraction of the engine from the car procedures of replacement of piston rings, pistons, rods and conrod bearings can be made. However, it is not necessary to practice such repair in a type of need of carrying out lot of preparatory work and careful respect for purity.