Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
- Line six-cylinder engine
   General information
   Repair procedures which implementation is possible without extraction of the engine from the car
   Reduction in the provision of VMT of a step of compression of the piston of the first cylinder
   Removal and installation of a cover of a head of cylinders
   Removal, check of a state and installation of yokes and bars of pushers
   Replacement of valvate springs, their plates and maslootrazhatelny caps
   Removal and installation of the inlet pipeline / final collector
   Removal and installation of a head of cylinders
   Replacement of a forward epiploon of a bent shaft
   Check of a state, removal and installation of a cover of a distributive chain, chain and its asterisks
   Removal, check of a state and installation of the camshaft, bearings and hydraulic pushers
   Removal and installation of the pallet of a case
   Removal, check of a state and installation of the oil pump
   Removal and installation of a flywheel / driving disk
   Replacement of a back epiploon of the crankshaft
   Check of a state and replacement of rubber pillows of support of the engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of a cover of a head of cylinders

 PERFORMANCE ORDER

  1. Remove a hose of CCV both a hose and a tube of ventilation of a case from a cover of a head of cylinders.

Location of hoses of CCV and ventilation of a case (shooter).

  1. Remove clips of a plait of wires, remembering the provision of their hairpins for the correct installation at assembly.
  2. Release from clips on the top part of a cover of a head of cylinders cables of gas, the drive of a butterfly valve in the mode kik-Down and control systems of speed (tempostaty). Disconnect cables from the case of a throttle and put them aside.
  1. Disconnect from the throttle case cables of gas, the drive of a butterfly valve in the mode kik-Down and a tempostat, release cables from clips on a cover of a head of cylinders and put them aside.
  1. Give fixing bolts and uncover a head of cylinders. If the cover "stuck", accurately tap it on perimeter the hammer with soft brisk. Do not try to hook a cover the lever started under the interfaced flange surface at all!
  2. Smooth out the interfaced surfaces, having carefully removed from them all traces of oil, having wiped with the rags moistened in acetone.

Such covers are equipped with the reusable laying formed of the stiffened RTV sealant and fastening directly to a cover.

  1. Existence in such laying of small cracks is admissible and is eliminated by greasing of the damaged site with RTV sealant before installation of a cover into place.
  2. Establish a cover and screw bolts. Tighten bolts with the required effort.
  3. Establish ventilating hoses and the servo-driver of a tempostat (if it is provided).
  4. Start the engine and check it for leaks.