Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   General information
   Care of a body
   Care of the finishing panels manufactured of vinyl
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Service of loops and locks
   Replacement wind and motionless glasses
   Removal, installation and adjustment of provision of a cowl
   Removal and installation of the lock of a cowl and cable of its drive
   Removal and installation to the place of the panel of a decorative front grille
   Removal and installation of a forward wing
   Removal and installation of bumpers
   Removal and installation of the panel of an internal upholstery of a door
   Removal, installation and adjustment of provision of a door
   Removal and installation of handles, cylinder and clamp (latch) of the lock of a door
   Removal and installation of a windowpane of a door
   Removal and installation of the regulator of a window of a door
   Removal and installation of the central console
   Removal and installation of the panel of an upholstery of a door of a back
   Removal, installation and adjustment of provision of a door of a back
   Replacement of an emphasis of a door of a back
   Removal and installation of facing of a combination of devices
   Removal and installation of facings of the control panel
   Removal and installation of the control panel
   Removal and installation of covers of a casing of a steering column
   Removal and installation of rear-view mirrors
   Remove also installation of a lattice of a fairing
   Removal and installation of seats
   Control body sizes
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the panel of an upholstery of a door of a back

 PERFORMANCE ORDER

  1. Give screws of fastening of the panel of an upholstery of a door of a back.
  1. The screw-driver with a crosswise sting give screws of the panel of an internal upholstery of a door of a back.
  1. Having carefully hooked the special tool (ask in shops of automobile accessories) or a spackling knife the upholstery panel, release its clamps. Without hurrying, release the panel on all its perimeter.
  1. By means of the special tool take clamps of an internal upholstery from a back door.
  1. After release of all clamps delay the upholstery panel up, disunite electric sockets of plaits of wires and remove the panel.
  2. For ensuring access to back door inside carefully separate from it the plastic sound insulator.
  1. Try not to tear and not to extend the sound insulator at office it from an internal wall of a door of a back.
  1. Before installation of the panel of an upholstery into place make sure available of it all clamps (some at removal could remain latched at doors).
  1. Take all clamps which remained in it from an internal wall of a door and transfer them to the upholstery panel.