Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   General information
   Care of a body
   Care of the finishing panels manufactured of vinyl
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Service of loops and locks
   Replacement wind and motionless glasses
   Removal, installation and adjustment of provision of a cowl
   Removal and installation of the lock of a cowl and cable of its drive
   Removal and installation to the place of the panel of a decorative front grille
   Removal and installation of a forward wing
   Removal and installation of bumpers
   Removal and installation of the panel of an internal upholstery of a door
   Removal, installation and adjustment of provision of a door
   Removal and installation of handles, cylinder and clamp (latch) of the lock of a door
   Removal and installation of a windowpane of a door
   Removal and installation of the regulator of a window of a door
   Removal and installation of the central console
   Removal and installation of the panel of an upholstery of a door of a back
   Removal, installation and adjustment of provision of a door of a back
   Replacement of an emphasis of a door of a back
   Removal and installation of facing of a combination of devices
   Removal and installation of facings of the control panel
   Removal and installation of the control panel
   Removal and installation of covers of a casing of a steering column
   Removal and installation of rear-view mirrors
   Remove also installation of a lattice of a fairing
   Removal and installation of seats
   Control body sizes
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Care of a body

The condition of a body of the car is extremely important factor when determining its resale price. The work of repair procedures for restoration of the damaged or started elements of a body is much more difficult, than performance of repair of mechanical components. The hidden areas of a body, such as wheel arches, a frame and a motive compartment, also need leaving, though do not require so frequent paying by it attention as other components of a body.

Once a year or each 20 000 km (12 000 miles) of a run it is desirable to make steam cleaning of internal surfaces of a body. After removal of all traces of dirt, oil and lubricant of a surface can be examined on existence of traces of corrosion, damage of brake lines, wear of isolation of an electrical wiring, damage of driving cables and other malfunctions. Upon completion of this work it is necessary to grease components of a forward suspension bracket.

At the same time you make steam cleaning or washing with the degreasing structure of external surfaces of the engine and a motive compartment.

Close attention has to be paid to arches of wheels as the sheeting can separate from from internal surfaces and the small stones and grains of sand which are taking off from protectors of wheels will cause damage of paint and, as a result, development of corrosion of panels. At detection of traces of corrosion (rust), they have to be removed to pure metal, and the surface is covered with anticorrosive paint

Sink bodies has to be made approximately once a week Carefully moisten car body surfaces for a softening of dirt which then wash away a soft sponge or a stream of water. Careless removal of the stuck dirt is fraught with damage of an external paint coat.

The spots of tar or asphalt getting on a body from the warmed paving can and have to be removed by means of the rags moistened in solvent.

Time in half a year rub a body and the chromeplated finishing elements with wax. Remember that when using for cleaning of the chromeplated surfaces of cleaners together with corrosion traces also a part of chroming will be removed - try to apply such solutions not too plentifully.