Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Check of a state, removal and installation of the steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   The angles of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of a bar of the back stabilizer of cross stability

Removal

 PERFORMANCE ORDER

  1. Car back also establish to Poddomkratta it on props.
  2. Disconnect connecting links (racks) of the stabilizer from bridge arms.
  1. Components of a rack of the back stabilizer; if dismantling of racks with the purpose of check of a condition of their components was made, installation them into place at assembly should be made according to this drawing.
  1. For a detachment of a rack of a bar of the back stabilizer from an arm of a tubular sleeve of the bridge give this nut (shooter) (the left rack is shown, for right the picture is identical).
  1. Otboltite collars of plugs of fastening of a bar of the stabilizer to frame beams also remove a bar from the car.
  1. For a detachment of a bar of the back stabilizer from beams of a frame give bolts (shooters) of collars of fixing plugs (left - for right everything similarly is shown).
  1. Remove collars and plugs from a bar of the stabilizer and check them for existence of cracks, signs of wear and the general aging of material. In case of need replace plugs.

Installation

 PERFORMANCE ORDER

  1. Put on plugs and collars a stabilizer bar. Lift a bar in adjusting situation, screw bolts and tighten them with the required effort.
  2. Connect stabilizer bar racks to arms of the bridge and tighten fixing nuts with the required effort.
  3. Remove jacks and lower the car on the earth.