Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Check of a state, removal and installation of the steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   The angles of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of forward shock-absorbers

Removal

 PERFORMANCE ORDER

  1. Weaken nuts of fastening of a wheel, the car and establish to a poddomkratta it on props. Cock the parking brake and remove a wheel.
  2. Give to a hook of the top rod of the shock-absorber. For keeping of a rod from a provorachivaniye use Rozhkov a key. If the nut "stuck", impregnate it with previously getting oil. Perhaps, for keeping a rod it is necessary to use самоконтрящимися nippers as for a usual key of a lyska on it are quite small.
  1. At an otdavaniye of a nut of a rod of the shock-absorber (shooter) for keeping of a rod from a provorachivaniye it is necessary to use Rozhkov a key or самоконтрящимися nippers.
  1. Give bolts and nuts of fastening of the lower support of the shock-absorber, then take the last through a wheel arch. Remove from the top part of the shock-absorber of a washer and rubber plugs through passage.
  1. The lower end of the shock-absorber fastens to a case of the forward bridge by means of two bolts (arrow) with nuts (in a picture are not visible).

Installation

 PERFORMANCE ORDER

  1. As much as possible stretch the new shock-absorber. Establish a new washer and the new rubber plug through passage on its rod, then fill the shock-absorber in the top support.
  2. Install the top rubber plug through passage with a washer and pull a rod for a guarantee of the correct centering of plugs in a support up-down. Strongly tighten a rod nut.
  3. Establish bolts and nuts of the lower support and reliably tighten them.