Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Check of a state, removal and installation of the steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   The angles of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of screw springs of a back suspension bracket

 PERFORMANCE ORDER

  1. Weaken nuts of forward wheels. A car front also establish to Poddomkratta it on props. Remove wheels.
  2. Mark situation and disconnect from the holder of a crosspiece of the leading gear wheel of differential the forward driveshaft (The head Stsepleniye and the transmission line), then tie up a shaft aside a piece of a wire.
  3. Prop up assembly of the bridge or one jack established under differential, or two, got under everyone their sleeves (the last way gives the best balancing). Otboltite the lower levers of a suspension bracket from the bridge (The section Removal and installation of levers of a forward suspension bracket).
  4. Otboltite of a rack of the stabilizer and shock-absorbers from a forward part of a case of the bridge (The sections Removal and installation of a bar of the back stabilizer of cross stability and Removal and installation of back shock-absorbers).
  5. Disconnect a jet bar from a bridge arm (The section Removal and installation of a cross jet bar of a back suspension bracket).
  6. Slowly omit assembly of the bridge so that screw springs completely stretched. If for supporting of the bridge only one jack is used, ask the assistant to hold the bridge on the right at its lowering. Take a spring from under the car.
  7. Check a spring for existence of defects and traces of corrosion which are capable to cause a premature exit it out of operation. In case of need make replacement.
  8. You make installation upside-down. Make sure of correctness of landing of a screw spring (see an illustration). Tighten all fixture with the required effort.