Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
- Brake system
   General information
   System of anti-blocking of brakes (ABS) - the general information
   Replacement of blocks of disk brake mechanisms
   Removal, capital repairs and installation of a support of the disk brake mechanism
   Check of a state, removal and installation of a brake disk
   Replacement of boots of drum brake mechanisms
   Removal, capital repairs and installation of wheel cylinders
   Removal and installation of the combined valve (regulator)
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake hoses and lines
   Pumping of the brake system
   Functioning check, removal and installation of the vacuum amplifier of brakes
   Functioning check, removal, installation and adjustment of the sensor switch of stoplights
   Adjustment of the parking brake
   Replacement of cables of the drive of the parking brake
   Replacement of boots of the parking brake (disk brake mechanisms of back wheels)
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of the main brake cylinder

This work also should not be performed by the amateur mechanic's forces. It is besides connected not with complexity of procedures of removal installation, and caused by need of carrying out adequate pumping of HCU. Manufacturers recommend to make preliminary pumping of the main cylinder on a workbench before installation on the car.

After installation is made, the main brake cylinder and HCU ABS have to be pumped over with use of the DRB II scanner (then all system has to be pumped over also in manual). The scanner is very expensive device and can serve as a favorable investment only for a workshop of dealer office. If on your car there are any problems connected with failures of the combined regulator tow off it in a workshop of dealer office or on specialized car repair shop.