Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
- Brake system
   General information
   System of anti-blocking of brakes (ABS) - the general information
   Replacement of blocks of disk brake mechanisms
   Removal, capital repairs and installation of a support of the disk brake mechanism
   Check of a state, removal and installation of a brake disk
   Replacement of boots of drum brake mechanisms
   Removal, capital repairs and installation of wheel cylinders
   Removal and installation of the combined valve (regulator)
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake hoses and lines
   Pumping of the brake system
   Functioning check, removal and installation of the vacuum amplifier of brakes
   Functioning check, removal, installation and adjustment of the sensor switch of stoplights
   Adjustment of the parking brake
   Replacement of cables of the drive of the parking brake
   Replacement of boots of the parking brake (disk brake mechanisms of back wheels)
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Adjustment of the parking brake

Models of 1993 of the issue.

 PERFORMANCE ORDER

  1. Make sure that drums (or disks) brake mechanisms of back wheels rotate freely, without zakusyvaniye, then completely cock the lever of the parking brake.
  2. Car back also establish to Poddomkratta it on props.
  3. Mark with chalk or a fatty pencil the provision of an adjusting nut on the tip of a natyazhitel of a cable equipped with a carving.
  1. On models of 1993 of the issue mark with chalk or a fatty pencil the provision of an adjusting nut (the left arrow) on the tip of a natyazhitel of a cable equipped with a carving, then screw a nut on about 13 mm more deeply on a tip; if carrying out replacement of a back cable is planned, squeeze its clamp (the right shooters) a small hose collar of worm type.
  1. Screw a nut more deeply on a tip of a natyazhitel approximately on 13 mm. If length of a carving part of a tip appears insufficiently, replace a natyazhitel (Section Replacement of Cables of the Drive of the Parking Brake). It is not necessary to try to improve a natyazhitel or to reuse him.
  2. Release the lever of the parking brake and make sure that back wheels rotate freely.
  3. Remove jacks and lower the car.
  4. Check functioning of brakes on a bias.

Models since 1994 of the issue.

 PERFORMANCE ORDER

  1. Make sure that drums (or disks) brake mechanisms of back wheels rotate freely, without zakusyvaniye, then completely cock the lever of the parking brake.
  2. Car back also establish to Poddomkratta it on props.
  3. Apply on a rod of a natyazhitel a tag approximately in 6,5 mm from an arm of a natyazhitel.
  1. On models 1994 and 1995 of of the issue apply on a rod of a natyazhitel a tag at distance of about 6.5 mm from an arm.
  1. Tighten an adjusting nut on the balance weight so that the tag on a rod of a natyazhitel was combined with his arm.

On any of the reasons do not tighten and do not weaken an adjusting nut of a natyazhitel after completion of adjustment!

  1. Release the lever of the parking brake and make sure that back wheels of the car rotate freely.
  2. Remove jacks and lower the car.
  3. Check functioning of brakes on a bias.