Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
- Brake system
   General information
   System of anti-blocking of brakes (ABS) - the general information
   Replacement of blocks of disk brake mechanisms
   Removal, capital repairs and installation of a support of the disk brake mechanism
   Check of a state, removal and installation of a brake disk
   Replacement of boots of drum brake mechanisms
   Removal, capital repairs and installation of wheel cylinders
   Removal and installation of the combined valve (regulator)
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake hoses and lines
   Pumping of the brake system
   Functioning check, removal and installation of the vacuum amplifier of brakes
   Functioning check, removal, installation and adjustment of the sensor switch of stoplights
   Adjustment of the parking brake
   Replacement of cables of the drive of the parking brake
   Replacement of boots of the parking brake (disk brake mechanisms of back wheels)
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Brake system

Specifications

General parameters

Type of brake fluid

Disk brake mechanisms

Minimum admissible thickness of a brake disk
It is beaten out or cast on a disk body
The most admissible fluctuations of thickness of a disk (mm)
  • Disk of the forward brake mechanism
No more than 0,013 mm
  • Disk of the back brake mechanism
No more than 0,025 mm
The most admissible beating of a disk (mm)
0,13
Minimum admissible thickness of brake shoes

Drum brake mechanisms

The most admissible diameter of a drum
It is beaten out or cast on a drum body
Minimum admissible thickness of frictional overlays of brake boots

Efforts of tightening of threaded connections, N • m

Nuts of fastening of the vacuum amplifier of brakes
41
Nuts of fastening of the main brake cylinder

13,0 — 24,9

Fixing pins of supports of brake mechanisms (forward and back)

9,5 — 20,3

Hollow bolt of fastening of a brake hose to a support of the brake mechanism (lobbies and back brake mechanisms)

31
Bolts of fastening of wheel cylinders
10,2