Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
- Coupling and transmission line
   General information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of switching off of coupling
   Removal, check of a state and installation of components of coupling
   Removal, check of a state and installation of the release bearing of coupling
   Check of a state and replacement of the directing bearing
   Driveshafts, differentials and bridges - the general information
   Check of a condition of the transmission line
   Removal and installation of driveshafts
   Replacement of cardan hinges
   Replacement of an epiploon of a shaft of the leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, capital repairs and installation of a forward power shaft
   Removal and installation of assembly of the forward bridge
   Removal and installation of a back half shaft and assembly of the bearing
   Removal and installation of assembly of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of components of hydraulic system of switching off of coupling

Components of assemblies of the main and executive cylinders of coupling


The hydraulic system of switching off of coupling is served as uniform assembly. If in system leaks appear or in it air gets, it is necessary to replace it also with the uniform block.


 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props.
  2. Give nuts of fastening of the executive cylinder to the coupling case.
  3. Release the hydraulic line of coupling from fixing clips on the case.
  4. Lower the car on the earth.
  5. Remove the holder's ring, flat and corrugated washers fixing a pusher of the main cylinder to a coupling pedal.

Details of knot of joining of a pusher with a coupling pedal.

  1. Disunite the electric socket of wires of the sensor switch of provision of a pedal of coupling, then remove a rod of a pusher of the main cylinder from a finger of fastening it to a pedal. Check a condition of plugs of a finger. Replace worn-out components.
  2. In order to avoid a spillage of liquid make sure that the cover of the tank of the main cylinder is densely closed, then give screws of fastening of the tank and a nut of hairpins of fastening of the cylinder to a partition of a motive compartment.
  3. Remove all assembly. Do not try to disconnect the hydraulic line from the main or executive cylinders.
  4. You make installation upside-down. Tighten all fixture with the required effort.