Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
- Coupling and transmission line
   General information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of switching off of coupling
   Removal, check of a state and installation of components of coupling
   Removal, check of a state and installation of the release bearing of coupling
   Check of a state and replacement of the directing bearing
   Driveshafts, differentials and bridges - the general information
   Check of a condition of the transmission line
   Removal and installation of driveshafts
   Replacement of cardan hinges
   Replacement of an epiploon of a shaft of the leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, capital repairs and installation of a forward power shaft
   Removal and installation of assembly of the forward bridge
   Removal and installation of a back half shaft and assembly of the bearing
   Removal and installation of assembly of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of a back half shaft and assembly of the bearing

Removal

 PERFORMANCE ORDER

  1. Weaken nuts of fastening of a wheel, a back of the car and establish to a poddomkratta it on props. Remove a wheel.
  2. Remove the brake drum, then give nuts of fastening of a board of the brake mechanism.
  1. Otbolite four nuts of fastening of a board of the brake mechanism using a head with the extender through an opening in a wheel nave.
  1. Connect the hammer with sliding brisk and a nozzle to a flange of a half shaft and take the last from a bridge sleeve.
  1. Take a half shaft from a bridge sleeve by means of the hammer with sliding brisk and nozzles on an axis flange.
  1. If the bearing is subject to replacement, deliver assembly in a workshop of car service or dealer office for removal of the old bearing and a press fitting on its new. At installation of the new bearing take care also of replacement of an external epiploon of a half shaft (see the following item).
  2. If on a board of the brake mechanism there are traces of leak of lubricant of differential, it is necessary to replace an external epiploon of a half shaft. Remove an old epiploon by means of the hammer with sliding brisk and a stripper in internal captures. Put a new epiploon by means of the special tool or a piece of a pipe of suitable diameter.
  1. Take a half shaft epiploon from a bridge sleeve by means of the hammer with sliding brisk with the stripper attached to it with internal captures.
  1. Grease epiploon sponges, then fill an epiploon on the place by means of the special tool or a piece of a pipe which outer diameter will be slightly less external diameter of an epiploon.

Installation

 PERFORMANCE ORDER

  1. Wipe a bearing nest in a bridge sleeve. Fill the bearing special (for wheel bearings) lubricant, apply also thin film of lubricant on the external surface of the bearing.
  2. Grease sponges of an internal epiploon, then fill a half shaft in a bridge sleeve, trying to hold it coaxially with the last not to damage an epiploon.
  3. Establish nuts of a board of the brake mechanism, strongly tighten them. Put on the brake drum a bridge flange.
  4. Establish a wheel and strongly tighten nuts of its fastening. Lower the car on the earth and tighten nuts of fastening of a wheel with the required effort (see Specifications to the Head Nastroyki and routine maintenance).