Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
- Coupling and transmission line
   General information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of switching off of coupling
   Removal, check of a state and installation of components of coupling
   Removal, check of a state and installation of the release bearing of coupling
   Check of a state and replacement of the directing bearing
   Driveshafts, differentials and bridges - the general information
   Check of a condition of the transmission line
   Removal and installation of driveshafts
   Replacement of cardan hinges
   Replacement of an epiploon of a shaft of the leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, capital repairs and installation of a forward power shaft
   Removal and installation of assembly of the forward bridge
   Removal and installation of a back half shaft and assembly of the bearing
   Removal and installation of assembly of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal and installation of assembly of the forward bridge

This procedure is equally applicable to models both 2WD, and 4WD. During the work on not all-wheel drive model lower excess steps.

Removal

 PERFORMANCE ORDER

  1. Weaken nuts of forward wheels, a front of the car and establish to a poddomkratta it on props. Remove forward wheels.
  2. Otboltite supports of forward brake mechanisms also tie up them aside by means of wire pieces - you watch that that brake hoses were not tense (The head the Brake system).
  3. Remove brake shoes, brackets of supports and brake disks (The head the Brake system).
  4. Mark position of the forward driveshaft in relation to a shaft of the leading gear wheel of differential, then disconnect the driveshaft from the holder of a crosspiece of a shaft of the leading gear wheel (Section Check of a Condition of the Transmission Line). Throw out collars of the holder of a crosspiece.
  5. Disconnect a stabilizer bar from arms on the bridge (The head Podvesk and steering).
  6. Disconnect steering drafts from levers of rotary fists (The head Podvesk and steering). Tie up them aside to car bottom elements pieces of a wire.
  7. Otboltite the lower ends of shock-absorbers from the bridge.
  8. Remove a steering damper (The head Podvesk and steering).
  9. Remove the ABS sensor (if it is provided) (for more details see the Head the Brake system).
  10. Get a hydraulic jack under differential. At a possibility of use of two jacks, place one of them under the right sleeve of the bridge for balancing of assembly (4WD). On models 2WD place a jack on the center of assembly of the bridge.
  11. Otboltite from the bridge the top and lower levers of a suspension bracket (The head Podvesk and steering).
  12. Slowly omit assembly on the earth.

Installation

You make installation upside-down. Lifting the bridge in adjusting situation, take care of the correct landing of screw springs. Do not forget to replace collars of the holder of a crosspiece. Tighten fixture mentioned in Specifications with the required effort.