Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
- Coupling and transmission line
   General information
   Coupling - the general description and check of serviceability of functioning
   Removal and installation of components of hydraulic system of switching off of coupling
   Removal, check of a state and installation of components of coupling
   Removal, check of a state and installation of the release bearing of coupling
   Check of a state and replacement of the directing bearing
   Driveshafts, differentials and bridges - the general information
   Check of a condition of the transmission line
   Removal and installation of driveshafts
   Replacement of cardan hinges
   Replacement of an epiploon of a shaft of the leading gear wheel of differential
   Removal, service and installation of a nave and bearings (forward wheel)
   Removal, capital repairs and installation of a forward power shaft
   Removal and installation of assembly of the forward bridge
   Removal and installation of a back half shaft and assembly of the bearing
   Removal and installation of assembly of the back bridge
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Removal, service and installation of a nave and bearings (forward wheel)

Removal

Assembly of a nave with the bearing and the accompanying components


This procedure is applicable only to models 4WD. On not all-wheel drive models bearings of tight type are used.


 PERFORMANCE ORDER

  1. Take off a nave cap, the forelock and a clamp of a nut, then give a nave nut.
  1. Before poddomkrachivat the car remove the forelock and a lock-nut, then weaken a nave nut.
  1. Weaken nuts of fastening of a forward wheel, a front of the car and establish to a poddomkratta it on props. Remove a wheel.
  2. Remove a support and a disk of the brake mechanism (The head the Brake system).
  3. Remove a nave nut. Otboltite assembly of a nave from a rotary fist also beat out it from a nest in a fist. If vents of a nave "stuck" to an axis, use a stripper.
  1. Give a forward bolt (shooter) …

… and two back bolts (arrow) of fastening of assembly of a nave to a rotary fist (the 12th beam head will be required).

  1. Carefully bring down assembly of a nave from a rotary fist.

Service

The nave block with the bearing is not subject to dismantling. In case of damage or wear of a nave or the bearing all assembly is subject to replacement.

Installation

 PERFORMANCE ORDER

  1. Emery paper smooth out an opening in a rotary fist, having removed from it all traces of corrosion and dirt. Grease vents driving and lubricant for wheel bearings. Use the same lubricant for greasing of walls of an opening in a rotary fist and establish assembly of a nave into place. Tighten bolts of fastening of a nave to a fist with the required effort.
  2. Establish into place a washer and a nut of a nave, strongly tighten a nut. Establish a disk and a support of the brake mechanism (The head the Brake system), put on a wheel and lower the car on the earth. Tighten nuts of fastening of a wheel with the required effort (The head Nastroyki and routine maintenance).
  3. Tighten a nave nut with the required effort, establish a clamp and the new forelock. Put on a nave cap.