Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a state and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of the parking lock
   Check of a state and replacement of a support of transmission
   Replacement of an epiploon
   Description of a design, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management of transmission (TSM) (only for AW-4 and 42RE)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Check of a state and replacement of a support of transmission

 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props.
  2. Under the car insert the big screw-driver or mount into space between lengthening of a case of transmission and a cross beam (model 2WD), or the transfer case and a cross beam (all-wheel drive models). Try to hook transmission or the transfer case slightly. Transmission should not rise a little considerably over a support pillow
  1. For check of a condition of a support of transmission insert mount or the big screw-driver between lengthening of a case and a cross beam (model 2WD) or between the transfer case and a cross beam (model 4WD) and try to raise this lever transmission over its support.
  1. For replacement of a pillow of a support give bolts of fastening it to a cross beam and to transmission.

Components of typical assembly of a support of transmission.

  1. Slightly raise transmission or the transfer case a jack and take a support pillow. Pay attention that the openings intended for centering of a support at its installation are provided in a cross beam.
  2. You make installation upside-down. Track reliability of tightening of fixture.