Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a state and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of the parking lock
   Check of a state and replacement of a support of transmission
   Replacement of an epiploon
   Description of a design, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management of transmission (TSM) (only for AW-4 and 42RE)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Adjustment of a cable of the parking lock

 PERFORMANCE ORDER

  1. Transfer the switching lever to situation "P", and the ignition key - to position of LOCK (Blocking).
  2. Give screws of fastening of facing of the lever of switching and consoles (Head Kuzov).
  3. For release of a cable delay the clamp button.
  1. For release of a cable delay the clamp button.
  1. Delay a cable forward, then release it and squeeze out the clamp button down to click.
  1. Delay a cable forward, then release it and squeeze out the clamp button down to click.
  1. For check of adjustment do the following procedures:
    • Transfer the switching lever to situation "P".
    • Check functioning of the button of release of a clamp in the handle of the lever and the cylinder of the lock of ignition. The button has to be in the free situation which is (wrung out), and the ignition lock cylinder freely to rotate between provisions of OFF and LOCK.
    • Transfer the switching lever to situation DRIVE (Movement) or REVERSE (Reverse gear) and again make sure of correctness of functioning of the cylinder of the lock of ignition. This time the cylinder should not rotate.
    • Check functioning of the lever of switching. Its conclusion from situation "P" has to be possible only when the cylinder of the lock of ignition is turned in position of OFF (Vykl), RUN (Movement) or START (Start). When finding the cylinder of the lock in provisions of ACCESSORY (Parking) or LOCK (Blocking).