Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a state and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of the parking lock
   Check of a state and replacement of a support of transmission
   Replacement of an epiploon
   Description of a design, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management of transmission (TSM) (only for AW-4 and 42RE)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)

Description

The butterfly valve from transmission copes by means of a cam on the lever of a throttle which, in turn, is given by an adjustable cable. The cable of TV is attached to the executive lever fixed on an axis of the lever of a butterfly valve. The lock button on a tip is intended for adjustment of a cable. The correct adjustment of a TV cable provides synchronization of the lever of a butterfly valve on transmission with the gate axis lever on the throttle case so the lever of a butterfly valve never advances the lever on the case of a throttle by transmissions and does not lag behind it.

Replacement

Components of the assembly of a TV cable used on AW-4 transmissions (only models of 1993 of the issue)


 PERFORMANCE ORDER

  1. Remove the air cleaner (The head of the Power supply system and production of the fulfilled gases).
  2. Disconnect a cable from draft of a butterfly valve on the throttle case.
Components of assembly of a cable of the butterfly valve used on transmissions 42RE (models 1994 and 1995 of of the issue).

For a TV cable detachment from draft of a butterfly valve on transmissions 42RH and 46RH shift this tip forward (the cable is turned therefore the flute on its wall which is usually turned to the throttle case is visible; the flute enters gearing with a pin on the lever of a butterfly valve).

  1. Squeeze fixing ears of a cable and take a cable from an arm on the engine.
  2. The car also establish to Poddomkratta it on props.

AW-4 (only models of 1993 of the issue)

 PERFORMANCE ORDER

  1. Remove the transmission case pallet (The head Nastroyki and routine maintenance).
  2. Disconnect a cable from a cam of a butterfly valve.
  1. Disconnect a TV cable from a cam of a butterfly valve (only AW-4 of models of 1993 of the issue).
  1. Give a bolt of an arm of a cable and remove an arm together with a cable from a case.
  1. Give a bolt of an arm of a cable and remove an arm together with a cable from a case (only AW-4na models of 1993 of the issue).
  1. Remove and throw out a cable sealant.
  2. Grease a new sealant and establish it on a cable.
  3. Enter a cable into a transmission case.
  4. Connect a cable to a cam of a butterfly valve.
  5. Establish a cable arm on a case and strongly tighten a fixing bolt.
  6. Install into place the transmission case pallet (The head Nastroyki and routine maintenance).

42RE and 42RH/46RH (models 1994 and 1995 of of the issue)

 PERFORMANCE ORDER

  1. Remove a cable from a hairpin on the lever of a butterfly valve on transmission.
  1. Disconnect a TV cable from the lever of a butterfly valve on transmission (transmission 46RH is shown; on transmissions 42RE and 42RH the picture is similar).
  1. Disconnect a cable from an arm on transmission.
  1. Release a TV cable from an arm on transmission (transmission 46RH is shown; on transmissions 42RE and 42RH the picture is similar).
  1. Establish a new cable in an arm.
  2. Fix a cable on a hairpin on the lever of a butterfly valve.

All models

 PERFORMANCE ORDER

  1. Remove jacks and lower the car on the earth.
  2. Fix in an arm on the engine and on draft of a butterfly valve a new cable (The head of the Power supply system and production of the fulfilled gases).
  3. Install into place the air cleaner (The head of the Power supply system and production of the fulfilled gases).
  4. Fill transmission with liquid of the required grade (The head Nastroyki and routine maintenance).
  5. Make adjustment of a cable.

Adjustment

AW-4 (only models of 1993 of the issue)

 PERFORMANCE ORDER

  1. Transfer transmission to situation "P" and make sure that the ignition key is turned in position of OFF. Squeeze out the button of release of a cable.
  1. Squeeze out the button of release of a cable, then push a cable cover in a case against the stop (only AW-4).
  1. Turn the lever of a butterfly valve on the throttle case, having completely opened the gate, allow a ratchet to reach the correct adjusting position at turn of the lever, then release the lever of a butterfly valve (AW-4).

42RE (models 1994 and 1995 of of the issue)

 PERFORMANCE ORDER

  1. Remove the air cleaner (The head of the Power supply system and production of the fulfilled gases).
  2. Make sure that the lever on the case of a throttle is in the provision of pure idling (the gate is closed) and that the lever of a butterfly valve on transmission also is in the provision of idling (will shift forward against the stop).
  3. Unhook a cable from a fixing hairpin on the lever on the throttle case (see the illustrations "Components of Assembly of a Cable of a Butterfly Valve..." and "For a TV Cable Detachment...").
  4. Check correctness of provision of a tip of a cable on a fixing hairpin of the lever of the case of a throttle:
    • The tip of a cable and fixing hairpin have to be combined (ottsentrovana the friend in relation to the friend) within 1.0 mm in both directions.
    • If violation of such centering takes place, it is necessary to make adjustment of a cable.
  5. Connect a cable tip to a hairpin.
  6. By means of the assistant estimate coherence of movements of levers to the gate on transmission and the case of a throttle.
    • If both levers move synchronously, passing from single situation into position of the half-open gate, adjustment is not broken.
    • If the lever of transmission advances the lever of a throttle or lags behind it, the cable has to be adjusted.
    • If the lever of the case of a throttle comes back to position of the closed gate quicker than the transmission lever, it is necessary to adjust a cable also.
  7. Disconnect a cable tip from a fixing hairpin of the lever of a butterfly valve on the throttle case (see the illustrations "Components of Assembly of a Cable of a Butterfly Valve..." and "For a TV Cable Detachment...").
  8. The car also establish to Poddomkratta it on props.
  9. Make sure that the lever of a butterfly valve on transmission is in position of completely closed gate. Then make sure that the gate lever on the case of a throttle is in the provision of pure idling (completely closed gate).
  10. Wring out the button of a clamp and release a cable. For release of a cable from an adjusting head it is enough to drown the button on 1,8 mm.

Details of installation of a TV cable on the lever on the throttle case (42RE and 42RH/46RH of models of 1994 of the issue).

Details of installation of a TV cable on the lever on the throttle case (42RE and 46RH of models of 1995 of the issue).

  1. Ottsentruyte a cable tip in relation to a fixing hairpin in the range of 1.0 mm also release the clamp button (see illustrations above).
  2. Check correctness of adjustment of a cable. Make sure of synchronism of operation of levers of the gate of transmission and the case of a throttle (see item 1-6).