Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a state and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of the parking lock
   Check of a state and replacement of a support of transmission
   Replacement of an epiploon
   Description of a design, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management of transmission (TSM) (only for AW-4 and 42RE)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Check of a state and adjustment of a cable of switching

Check

Cock against the stop the parking brake and make attempts of short inclusions of a starter at all provisions of the lever of switching. Inclusion of a starter has to take place only in provisions of the lever "P" and "N". If the starter is started at any of other provisions of the lever, make adjustment of draft (see below). If after adjustment the starter still joins at excellent from "Р" or "N" provisions of transmission, it is necessary to make adjustment of the sensor switch of permission of start or to replace it (The section Serviceability Check, adjustment and replacement of the sensor switch of permission of start).

Adjustment

 PERFORMANCE ORDER

  1. Install the switching lever in situation "P". The car also establish to Poddomkratta it on props.
  2. For release of a cable of switching separate a cable casing from an arm, then, for release of a cable release its adjusting clip.
  1. The cable of switching is connected to the switching lever by means of the docking socket of shariko-nested type; for a socket rassoyedineniye just knock over a cable tip from a small pin on the lever by means of the screw-driver.
  1. For a cable detachment from an arm flat-nose pliers squeeze together lock uvulas of a casing, then delay a cable with a casing from an arm.
  1. Make sure that the lever of switching to transmissions is taken away against the stop back on the last clamp. At the same time transmission will be in situation "P".
  2. Make sure that the parking lock works for what make attempt to rotate the driveshaft. At normal functioning of the lock the shaft cannot be turned.
  3. Latch a switching cable casing in an arm, then press an adjusting clip down to click, having recorded thereby a cable.
  4. Lower the car on the earth.
  5. At reliably cocked parking brake make sure that inclusion of a starter is possible only in provisions of transmission "Р" and "N". If draft is adjusted normally, however the starter is started in provisions excellent from "Р" and "N", check serviceability of the sensor switch of permission of start (The section Serviceability Check, adjustment and replacement of the sensor switch of permission of start).
  6. Check smoothness of functioning of the lock of blocking of a steering wheel.