Jeep Grand Cherokee
1993-1999 of release
Repair and operation of the car
Jeep Grand Cherokee
+ Cars of the Jeep Grand Cherokee brand
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
Diagnostics of malfunctions - the general information
Removal and installation of the lever of switching
Check of a state and adjustment of a cable of switching
The description, replacement and adjustment of a cable of the drive of a butterfly valve in the mode kik-Down (TV cable)
Serviceability check, adjustment and replacement of the sensor switch of permission of start
Adjustment of a cable of the parking lock
Check of a state and replacement of a support of transmission
Replacement of an epiploon
Description of a design, removal and installation of lines and hoses of cooling of transmission
Removal and installation of an additional cooler
Removal and installation of automatic transmission
Replacement of the module of management of transmission (TSM) (only for AW-4 and 42RE)
Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ System of onboard electric equipment
+ Governing bodies and methods of operation
All models of the brand of cars described in this manual are equipped or a five-step manual box (switching) of transfers (RKPP), or the four-stage automatic transmission (AT). All information on AT contains in this Chapter. Information on RKPP can be found in the Part the Manual box of gear shifting of this Chapter. All-wheel drive models are equipped with also transfer case. Information on the transfer case is provided in the Part the Transfer case of the Head.
In view of complexity of a design of AT and need of use of the special equipment for performance of the majority of procedures of its service this Chapter mainly included only descriptions of procedures of the general diagnostics of malfunctions, routine maintenance, adjustment and removal installation.
Capital repairs of transmission (if in that there is a need) have to be made by specialists of dealer office or a workshop of car service. However, performing procedures of removal and installation of transmission quite on forces to the average amateur mechanic that allows to cut down significantly expenses on metalwork works at delivery of transmission in repair.
On cars to which this manual is devoted electronically controlled AT of four various types can be applied. Transmission of the AW-4 type is used only on models of 1993 of the issue. Transmissions 42RE, 42RH and 46RH have a similar design (but AW-4, other than a design) and issues are used on models since 1994. And transmissions 42RE and 42RH are applied only complete with 6 cylinder engines whereas 46RH is established on all models equipped with the V8 engine.
If you are the owner of the model of 1994 of the issue equipped with the 6th 4.0 l cylinder engine, then on your car transmission of type either 42RE, or 42RH will be established. The simplest way of examination like transmission is survey from below of the pallet of its case after preliminary raising and reliable fixing of the car. Pallets of cases of transmissions of type 42RE are quite superficial and have the turned camber on the right on the bottom; pallets of transmissions 42RH are deeper also flat-bottomed.
All models since 1995 the issue are equipped with transmissions of type 42RE.