Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   + Technology of service, tool and equipment of a workplace
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Start of the engine from the auxiliary power supply

At start of the engine from the auxiliary battery it is necessary to remember need of implementation of the following requirements:

  • Before connection of the auxiliary battery make sure that ignition is switched off (the key is turned in position of OFF).
  • Make sure that all electric equipment of the car is switched off (lighting fixtures, a heater, screen wipers, etc.).
  • Surely put on goggles.
  • Make sure that the auxiliary battery on output tension corresponds established on your car.
  • If start is made from the battery installed on other car, track that between cars there was no common ground!
  • Make sure, transmission is established on neutral transfer (RKPP), or in situation "P" (Parking) (AT).
  • If the auxiliary battery belongs to type of subjects to service, remove from it ventilating covers and cover openings with rags.

Connect a red wire from a set for start of the engine from an auxiliary source between positive (+) plugs of both batteries. Then connect the second (black) wire from a set at first to the negative plug of the auxiliary battery, and then to well grounded point on your car (such as bolt or arm on the engine block, whenever possible within distance in 45 cm from the battery). Make sure that wires do not touch moving components of a motive compartment (such as fan blades, driving belts, etc.).

Connect wires from a set for start of the car from the auxiliary power supply in the order shown in the drawing (pay attention that the negative wire of NOT auxiliary battery is connected to the negative plug of the sat-down battery).

Start the engine from the auxiliary battery, then, having left it working at single turns, turn on the heater fan motor (on the maximum speed) or a heater of glass for smoothing of peaks of tension which can arise at a detachment of wires (do not turn on lighting fixtures since considerable power surges can lead to burn-out of lamps). Disconnect wires, working as it should be the return to an order of their connection.