Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   - Technology of service, tool and equipment of a workplace
      Technology of service
      Fixture
      Fixture sizes
      Procedure and order of tightening of threaded connections
      Dismantling of components
      Pro-masonry surfaces
      Councils for removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Workplace equipment

Speaking about the tool, it is necessary to remember the workplace equipment. If carrying out more serious work, than simple maintenance is necessary, it is necessary to take care of preparation of the suitable working platform.

It is necessary to recognize that many motorists are forced to make removal of the engine and other similar works not in the conditions of a garage or a workshop. However, anyway the important requirement is existence of a roof or awning.

Whenever possible, any procedures for dismantling of parts of systems of the car have to be made on a pure flat workbench, or a strong table of convenient height. The workbench has to be surely equipped with a vice. Existence of a vice with disclosure of sponges to 100 mm and with soft overlays for sponges is sufficient.

As it was already mentioned above, on the working platform the pure dry place for storage of the tool, lubricant and cleaning liquids, hard putties, paints and varnishes, etc. has to be equipped.

It is necessary to notice that absolutely necessary tool is the electric drill, therefore, the working platform has to be equipped with the power supply for its connection. Existence of a drill with the boss to 9.5 mm and a set of qualitative drills considerably will facilitate holding many procedures.

At last, in a workplace always there has to be a sufficient stock of old newspapers and pure, not ворсящейся rags, intended for cleaning of the working platform, the tool and details of the car.

Working off should be handed over in the centers for utilization in a tight container.

Never you perform any works on the barefaced painted surface of the car, use protective overlays for wings, or, at the worst, cover the polished surfaces with old blankets.