Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   - Technology of service, tool and equipment of a workplace
      Technology of service
      Fixture
      Fixture sizes
      Procedure and order of tightening of threaded connections
      Dismantling of components
      Pro-masonry surfaces
      Councils for removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Councils for removal of hoses

If your car is equipped with the air conditioning system, do not disconnect from conditioner components any hoses at all until the system is not discharged in representative office of the company or the specialist in air conditioning systems of a workshop of car service.

Measures of precautions which should be observed at removal of hoses are very close to those at removal of laying. Avoid damage of surfaces of unions and branch pipes on which hoses as it can be the cause of leaks put on. In a special measure it belongs to the procedure of removal of hoses of a radiator. Owing to various chemical reactions occurs "prikipany" rubbers of hoses to the interfaced surfaces of unions and branch pipes. For removal of a hose first of all weaken a collar of fastening it on the union. Then nippers with the sliding hinge grasp a hose near a collar and begin to rotate it on the union / a connecting branch pipe to the right-to the left. Continue this procedure before liberation of a hose, then remove a hose from the union. A small amount of silicone or other lubricant will facilitate the procedure if it can be entered into a gap between the union and a hose. For simplification of the procedure of installation of a hose grease an internal surface of a hose and the external surface of the union.

As the last resort, or in case of unambiguous need of replacement of a hose by the new, put-on the union end of a hose for removal can be knifed and then is separated from the surface of the union. At the same time try not to damage a knife union metal / under connecting a branch pipe.

In case of damage of a collar of fastening of a hose replace it with new. Collars of the twisted type usually weaken eventually therefore, regardless of their state, as required it is better to replace them with collars of screw type.