Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   - Technology of service, tool and equipment of a workplace
      Technology of service
      Fixture
      Fixture sizes
      Procedure and order of tightening of threaded connections
      Dismantling of components
      Pro-masonry surfaces
      Councils for removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Dismantling of components

Dismantling of all components has to be carried out in such manner that at assembly each detail could be established on the former place and the correct image. Remember characteristics of appearance, in case of need you make landing marking of details which installation can be into place made ambiguously (the persistent washer equipped with a flute on a shaft belongs to such elements, for example). The arrangement of the removed details on a pure working surface in that order in what their removal was made will be the good idea. Useful will be also a drawing up the elementary schematic sketches or step-by-step photography of the component which is subject to dismantle.

At removal of fixture try to make marking of its initial situation on assembly. Often, immediate installation of fixture and washers on the former place after removal of the corresponding detail allows to avoid confusion at assembly. In the absence of such opportunity, all fixture should be put in specially prepared for this purpose broken into sections and respectively the marked box, or just on the separate marked boxes. Such line of action is especially useful during the work with the components consisting of a set of fine details such as carburetor, generator, valvate mechanism, dashboard or elements of a decorative upholstery of salon.

At a detachment of electric contacts and sockets it is necessary to pay attention to marking of wires or plaits by means of an insulating tape with the digital or alphabetic code applied on it.