Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   - Technology of service, tool and equipment of a workplace
      Technology of service
      Fixture
      Fixture sizes
      Procedure and order of tightening of threaded connections
      Dismantling of components
      Pro-masonry surfaces
      Councils for removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Fixture

Fixture are called nuts, bolts, hairpins and screws serving for connection among themselves of two or more details. During the work with fixture it is necessary to remember some things constantly. Practically in any fixture this or that type of the kontryashchy and stopping devices is applied. It can be lock washers, lock-nuts, lock tags or the fixing compound for carvings. All used carving fixture has to be absolutely pure and direct, with an undisturbed carving and not rounded corners of six-sided heads which the wrench is put on. It is necessary to take obligatory replacement of the damaged nuts and bolts by new for the rule. Special самоконтрящиеся nuts with nylon or fiber inserts are not subject to reuse as at an otdavaniye lose the kontryashchy properties and at assembly always have to be replaced with new.

The rusted bolts and nuts for simplification of unscrewing and in order to avoid damage before an otdavaniye have to be processed by the special getting structure. Many mechanics prefer to use turpentine which is convenient for putting from a special small canister with a long nose for this purpose. After wetting of the "stuck" fixture by the getting structure before starting its otdavaniye, it is necessary to give to structure within several minutes properly to impregnate the oxidized contact layer. Strongly rusted fixture can be cut down by a chisel, is cut by a hacksaw or removed by means of a special gaykolom.

When cutting a head of a bolt or oblamyvaniya of a hairpin on assembly, the rest of a carving part can be drilled or taken by means of the special tool. Most auto repair shops can undertake performance by this, also as well as others (for example, restoration of the stripped thread in carving openings), repair procedures.

Flat and lock washers at assembly have to be established always into place in the same order and the same way, as earlier. Always replace the damaged washers with new. Between a lock washer and a soft metal surface (for example aluminum), thin sheet metal or plastic it is always necessary to establish flat washers.