Jeep Grand Cherokee

1993-1999 of release

Repair and operation of the car



Jeep Grand Cherokee
- Cars of the Jeep Grand Cherokee brand
   + Identification numbers of the car
   Acquisition of spare parts
   + Technology of service, tool and equipment of a workplace
   + Poddomkrachivaniye and towage
   Start of the engine from the auxiliary power supply
   + Automobile chemicals, oils and lubricants
   - Diagnostics of malfunctions
      Engine
      Engine electric equipment
      Power supply system
      Cooling system
      Coupling
      Manual Box of Gear Shifting (MBGS)
      Automatic Transmission (AT)
      Transfer case
      Driveshaft
      Bridges
      Brake system
      Suspension bracket and steering
+ Settings and routine maintenance
+ Line six-cylinder engine
+ V8 engine
+ Procedures of the general and capital repairs of the engine
+ Cooling systems, heating and air conditioning
+ A power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and methods of operation



Manual Box of Gear Shifting (MBGS)

Everywhere, where it is not specified especially, references to the Head's materials Automatic transmission are meant.

At established on neutral transfer of the check point in operating time of the engine extraneous noises take place

  1. The bearing of a main shaft is worn-out.
  2. The bearing of the leading gear wheel of the conducted shaft is damaged.
  3. Bearings of an intermediate shaft are worn-out.
  4. Washers of adjustment of an axial side play of an intermediate shaft are worn-out or damaged.

Extraneous noises take place in any provision of RKPP

  1. Any of the above-mentioned reasons and/or:
  2. In the check point the insufficient amount of gearbox oil is filled in (its level) (see the checks listed in the Head Nastroyki and routine maintenance fell).

Extraneous noises arise on any concrete transfer

  1. Teeth of a gear wheel of this transfer are worn-out, damaged or chopped off.
  2. The synchronizer of this transfer is worn-out or damaged.

There are "soskakivany" check points from the highest transfer

  1.  Fastening of a box on a coupling case weakened.
  2. Between the boat of a box and the engine dirt got or the box was displaced in relation to the engine.

At gear shifting there are complications

  1. It is squeezed not completely out coupling (is switched off) (see the description of adjustment of coupling in the Head Nastroyki and routine maintenance).
  2. Draft of switching is damaged, its fastening weakened or adjustment is broken. Make careful check of a condition of components, in case of need replace defective.

Leak of gearbox oil takes place

  1. In the check point the excessive amount of gearbox oil is filled (the description of the procedure of check of level of oil see in the Head Nastroyki and routine maintenance). In case of need merge surplus.
  2. The epiploon of a box or epiploon of a driving gear wheel of a speedometer needs replacement.